Installation – Circular Connectors

EESeal® EMI Filter Installation For Circular Connectors

The design and construction of EESeal® FilterSeals makes them easy to install by hand, without special tools, but care is needed to ensure proper insertion.

View Printable Installation Instructions for Circular Connectors

Not the right connector type? View instructions for DSub Connectors or MDM Connectors.

Step 1: Which side is UP?

The side with the EESeal® logo is facing up and is visible after the EESeal® is inserted.

Important Note: t is imperative that the EESeal® be inserted “right side up”. Failure to do so will prevent the EESeal® from working as it’s intended to, and may cause functional problems.

Which side is up on an EESeal? Diagram shows the top contains the EESeal logo and the "A" Pinhole.

Step 2: Orient the EESeal®

With the correct side up, orient the EESeal® so its pinholes roughly align to the corresponding pins in the host connector. Most EESeal® FilterSeals have at least pin A (or pin 1 if your connector has numbers) marked to assist you in this orientation.

Important Note: It is imperative that the EESeal® be inserted so its pinholes are aligned with the matching pins in the connector – pin A to pin A, or pin 1 to pin 1, and so on. Your EESeal® may have a different treatment for each pin, and proper orientation will ensure each pin gets the correct circuit connection.

Installation Step 2: Orient the EESeal

Step 3: PARTIALLY Insert the EESeal®

Slightly cup the EESeal® so that Pinhole A (or pin 1) can be easily slipped onto the corresponding pin in the host connector. Double-check that the corresponding EESeal® pinholes are going over the correct pins in the connector. Gently use your fingertip to push the EESeal® down just over the tip of the pin, no further. Now simply press the rest of the pins into the EESeal® pinholes in the same manner. To make the EESeal®go on easily, notice that the EESeal® is intentionally oversized, so your pressing action should be towards(not away from) the pins already completed. Do not attempt to push the EESeal® down any further than just over the tip of the pins.

Installation Step 3: PARTIALLY Insert the EESeal®. Lightly push the "A" pinhole onto just the tip of pin A. Partially insert just the tip of the pins into the pinholes.

Step 4: Fully Insert & Seat the EESeal®

First, confirm that you can see the tip of each and every pin slightly poking through its corresponding EESeal® pinhole (if not, complete step 3 before proceeding). The EESeal® can be fully inserted and permanently seated by simply mating the connector pair. Do not use your finger or any tool to seat the EESeal®, doing so may cause damage to the EESeal®. Now check the EESeal® to ensure it is flat at the bottom of the connector, with no folds along its edge or interior. It should appear like it belongs there. If you notice anything unusual, please contact us.

Installation Step 4: Fully Insert and Seat the EESeal. Mate the connector pair to seat the EESeal, so all of the pins are fully exposed.

Questions?

Please call (505) 243-1423 or email EESeal@Quell.US for help.

Request Your FREE Generic or Custom EESeal or EESeal+ Sample